– wiring (Denso) for Wingroad with Y12, Electrics. Frame / Series, Y12 / Y12, body, W (wagon), engine, HR15DE (HR15DE engine), drive, 2WD. HR15DE engine model. flexible wires and anchors, work properly. If loose parts, deterioration, cuts .. to any components or wiring of the supple- mental air . HR15DE engine torque curve. Achieves plentiful low-end torque extending through mid-to-high engine speed. MR20DE engine torque curve. liter engine.

Author: Ditilar Zologul
Country: Benin
Language: English (Spanish)
Genre: Marketing
Published (Last): 6 September 2013
Pages: 460
PDF File Size: 20.24 Mb
ePub File Size: 8.6 Mb
ISBN: 717-9-39492-133-2
Downloads: 4349
Price: Free* [*Free Regsitration Required]
Uploader: Misho

No load Idle 2, rpm Clutch pedal: ON] — [Ignition switch: For 1 seconds after turning ignition switch: No load Not used.

Idle air volume learning has not been performed yet. Engine is revving from idle to about 4, rpm — 0.

Response ratio Lean to Rich Response rate: Accelerator pedal position sensor 2 signal and throttle position sensor 2 signal are converted by ECM internally. When the fail-safe operations for both self-diagnoses occur, the MI illuminates.

HR15DE Wire Harness – Engine – Tiida – Nissan

Permission Reusing this file. Fully released Clutch pedal: ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening approx. After warming up, idle the engine More than seconds after starting engine?

  GEMATRIA CROWLEY PDF

Slightly depressed Air conditioner switch: Engine stopped [Engine is running]?

I, the copyright holder of this work, hereby publish it under the following licenses:. Therefore, acceleration will be poor. Engine coolant temperature will be determined by ECM based on the following conditions. When throttle valve opening angle in fail safe mode is not in specified range: A few seconds after turning ignition switch OFF [Ignition switch: Idle speed [Engine is running]?

APEXi SMART Accel Controller Harness Adapter – A017 – RHDJapan

Adjust ignition timing with a timing light before monitoring IGN TIMING, because the monitor may show the specification data in spite of the ignition timing not being adjusted to the specification data. Under the following conditions? More than a few seconds after turning ignition switch OFF 0 – 1.

More than 1 second after turning ignition switch ON [Engine is running] [Ignition switch: Specification data are reference values. When electric throttle control actuator does not function properly due to the return spring malfunction: When disconnecting ECM harness connector Aloosen C it with levers as far as they will go as shown in the figure.

  LIFE AS THEATER A DRAMATURGICAL SOURCEBOOK PDF

ON] — — [Ignition switch: Fully depressed — [Engine is running]?

For 1 second after turning ignition switch ON [Engine is running] [Ignition switch: The following other wikis use this file: ON Compressor operates — [Ignition switch: You may select the license of your choice. The engine speed will not rise more than 2, rpm. After warming up – Keeping the engine speed between 3, and 4, rpm for 1 minute and at idle for wiriny minute under no load? After warming up – After keeping engine speed between 3, and 4, rpm for 1 minute and at idle for 1 minute under no load?

Fully released Brake pedal: